Hi,

I had some troubles adding devices through the UI too and switched to doing it manually.  I tend to add devices in bulk so I wrote a wrapper script to accept device names from a file.  Works perfectly!

 

- Jared

From: Tom Laermans <tom.laermans@powersource.cx>
To: Observium Network Observation System <observium@observium.org>
Sent: Thursday, June 6, 2013 5:31 AM
Subject: Re: [Observium] Setup problem

I almost never add devices manually :]

On 6/06/2013 14:25, Adam Armstrong wrote:
>
> I still don't think we should allow adding of devices on the web
> interface. It's never been reliable.
>
> adam.
>
> On 2013-06-06 13:19, Tom Laermans wrote:
>> Also, adding devices through the web interface is a bit iffy, try from
>> the command line.
>>
>> Tom
>>
>> On 6/06/2013 14:09, Jason Lixfeld wrote:
>> I dunno.  Check the database to see if the host got installed there. 
>> If not, try to snmpwalk the device from the CLI with the same polling
>> information you fed into Observium.  Also make sure your permissions
>> are correct in /opt/observium for your system.
>>
>> On 2013-06-06, at 7:58 AM, Support <caretechtest@gmail.com> wrote:
>>
>> Hi,
>>
>> I know it.. but i am getting error..
>>
>> Please verify the snapshot.
>>
>> Thank you.
>>

Please cut off some unnecesary shit on these huge posts. :P
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium