Hello
First thing, does the attach show anything I need to be concerned about? The warnings, although 6 days ago I'm not understanding where they came from. These are new switches, all 3 fans installed and green lights. Airflow sufficient and cooled.
Secondly, I have 3 ports showing a CBQoS error. I checked and see it's due to packet loss because of rate limiting policy set previously. Running Cisco 3650. I've removed the policies from each of the port's VLANs assigned over an hour ago and Observium is still showing as the policies in place? It polled ample times on all ports but not quite sure why it's still showing the policies and errors? I did notice at least that it showed no packet loss once I removed the policies, but the error bubble is still there and it still shows the policy name when viewing the CBQoS page for the ports.
From the Switch
Switch2#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch2(config)#int gi2/0/14 Switch2(config-if)#no service-policy output speed25 % policy map speed25 not configured
Switch2#sh platform qos policies port Policy: None in the list
Switch2#show run interface gi2/0/14 Building configuration...
Current configuration : 113 bytes ! interface GigabitEthernet2/0/14 description Server 19 switchport access vlan 19 switchport mode access end
