Just for reference, this is the “show interface” for the port in the graph…I understand that “show interface” shows a cumulative number while the graph is not….but as you can see, there have been 1241 input errors
 since the last reset…..that is no where near 44m?
Hence my confusion
thanks
GigabitEthernet0/0 is up, line protocol is up
  Hardware is CN Gigabit Ethernet, address is 68ef.bd99.dca0 (bia 68ef.bd99.dca0                                                )
  Description: lan
  Internet address is 1.1.1.1/24
  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
     reliability 255/255, txload 2/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full Duplex, 1Gbps, media type is RJ45
  output flow-control is unsupported, input flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/13/11228 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 954000 bits/sec, 535 packets/sec
  5 minute output rate 8346000 bits/sec, 885 packets/sec
     3637522994 packets input, 1559853723 bytes, 0 no buffer
     Received 11917322 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 1 throttles
     1241 input errors, 0 CRC, 0 frame, 1241 overrun, 0 ignored
     0 watchdog, 177941 multicast, 0 pause input
     322101698 packets output, 1529083260 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     403 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out
From: Tony Guadagno via observium <observium@lists.observium.org>
Sent: Monday, December 4, 2023 2:12 PM
To: Observium <observium@lists.observium.org>
Cc: Tony Guadagno <tonyg@guadagno.org>
Subject: [Observium] units on error graphs?
Hi, sorry if this is obvious, but it just occurred to me that I don’t understand this graph.  This comes from an Ethernet port on a cisco router….

What are the units??for example the “last in errors/s” is 44.25m????   44.24 million?  That can’t be right.
Thanks in advance
Tony Guadagno
O +1 585 577 1003
C +1 585 703 6700
E tonyg@guadagnoconsulting.com
