What is the output from the SNMP walk, earlier in the debugging output?
Thanks, adam.
On 2014-03-13 19:48, Jeeves wrote:
Hi, thanks for your reply. It doesnt seem to see any data on the port when I run that command (see output at end of post).
If I use iReasoning MIB browser and do an SNMP walk, ifInOctets.21 (port 20) shows 212492177, and a couple seconds later shows 212532659. So it appears as though the switch is showing data thrugh via SNMP. The other active ports also have data increasing on the ifInOctets SNMP entry.
Got any suggestions on what to try next?
Heres the output for Fa0/20. In fact all the ports show the same as this.
SQL[UPDATE `ports-state` set `poll_time` ='1394760997',`poll_period` ='632',`ifInOctets` ='0',`ifInOctets_rate` ='0',`ifInOctets_delta` ='0',`ifOutOctets` ='0',`ifOutOctets_rate` ='0',`ifOutOctets_delta` ='0',`ifInErrors` ='0',`ifInErrors_rate` ='0',`ifInErrors_delta` ='0',`ifOutErrors` ='0',`ifOutErrors_rate` ='0',`ifOutErrors_delta` ='0',`ifInUcastPkts` ='0',`ifInUcastPkts_rate` ='0',`ifInUcastPkts_delta` ='0',`ifOutUcastPkts` ='0',`ifOutUcastPkts_rate` ='0',`ifOutUcastPkts_delta` ='0',`ifInOctets_perc` ='0',`ifOutOctets_perc` ='0',`ifOctets_rate` ='0',`ifUcastPkts_rate` ='0',`ifErrors_rate` ='0' WHERE `port_id` = '297'] 1 updated Port FastEthernet0/20(21) replacing with 64-bit...VLAN == 1 ifInOctets (0 B) 0 Bps 632 secs
ifOutOctets (0 B) 0 Bps 632 secs
ifInErrors (0 B) 0 Bps 632 secs
ifOutErrors (0 B) 0 Bps 632 secs
ifInUcastPkts (0 B) 0 Bps 632 secs
ifOutUcastPkts (0 B) 0 Bps 632 secs bps(0bps/0bps)bytes(0B/0B)pkts(0pps/0pps)RRD[cmd[update /opt/observium/rrd/pureip-office-switch2/port-21.rrd N:0:0:0:0:0:0:618:882734:2:0:0:U:U:U:U] stdout[OK u:0.01 s:0.01 r:54.03 OK u:0.01 s:0.01 r:54.04] stderr[]]
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium