Oh, so you get the sensors in Observium but it shows them as wrong type of sensor? Then please attach a screenshot and run polling.php and discovery.php towards this device and use the -d flag for debug. example: ./discovery.php -h mydevice.com -d save the debug output to a pastebin or similar and give us the link :) /Markus
2016-09-05 9:15 GMT+02:00 David Schrok dr.schrok@avans.nl:
Thak you for your reply.
If I add a MIB, can it then make a difference between temp and humidity readout?
Now all sensors of the new probe are shown in temperature.
Met vriendelijke groet,
David Schrok
Systeem- en netwerkbeheerder
Avans Hogeschool
Diensteenheid ICT en Facilitaire Dienst (DIF)
Afdeling ICT-BO
Bijster 7-21
Ruimte DB122
4817 HZ Breda
T (088) 525 7528
M 06 10040414
E dr.schrok@avans.nl
*Van:* observium [mailto:observium-bounces@observium.org] *Namens *Markus Klock *Verzonden:* maandag 5 september 2016 07:52 *Aan:* Observium Network Observation System observium@observium.org *Onderwerp:* Re: [Observium] SNMP MIB Import
Hi David,
Sadly just adding a MIB will not add support for a device, a SNMP MIB is only translating OID numbers, nothing more.
Observium needs code written to actually support a new device, how much code depends on what kind of sensors you would like to support.
/Markus
2016-09-05 7:37 GMT+02:00 David Schrok dr.schrok@avans.nl:
Hello,
Is there a wau to import MIB’s for devices that aren’t supported by Observium yet?
I bought a new environment sensor which isn’t recognized by observium. I have the MIB’s, just don’t know how to import, if that is even possible.
Any help?
With Kind Regards,
David
Disclaimer ( http://www.avans.nl/over-avans/e-mail-disclaimer )
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
Disclaimer ( http://www.avans.nl/over-avans/e-mail-disclaimer )
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium