Did you type

cd /opt/observium

sudo chmod 755 rrd

Sincerely,

Joshua Hopper, A+ CE

Network Administrator

420 3^rd Ave NW Hickory NC 28601

Office: 828-449-1839x2160 | Cell: 828-855-7565

From: observium [mailto:observium-bounces@observium.org] On Behalf Of Vmman
Sent: Thursday, December 12, 2013 5:39 PM
To: Observium Network Observation System
Subject: Re: [Observium] New install no graphs

when I run the command ./poller.php -h all as the install guide shows I get a permission denied.

when I run it like this php poller.php -h all it runs fine.

I think that is why my cron job is not working correctly. Is yours running exactly as install guide show? Thanks

On Thu, Dec 12, 2013 at 3:03 PM, Josh Hopper <joshhopper@protectplus.com> wrote:

Verify cron and your SNMP.conf file.

It took a discovery poller and time before mine populated.

Vmman <vmman50@gmail.com> wrote:

Thank you

I'm monitoring a device that I did not not setup, spoke too soon on the graphs. I think my cron job is not working correctly.

After doing the chmod on the rrd directory I did a polling manually and now I see memory, processor, temp reading but no graphs. So close

Mark

On Thu, Dec 12, 2013 at 2:37 PM, Josh Hopper <joshhopper@protectplus.com> wrote:

Add a sysContact to your switch and add it on the device in observium. Click the gear when drilled down to a device. Just the switch one is required but both helps in rare cases.

Also, my pleasure.

Vmman <vmman50@gmail.com> wrote:

Joshua thank you very much, that seems to have worked.

Sorry to bug you I have another question

I'm monitoring a Cisco switch, how do you get the location correct on the global map?

Mark

On Thu, Dec 12, 2013 at 1:34 PM, Josh Hopper <joshhopper@protectplus.com> wrote:

You have the same issue I just fixed.

Chmod 775 on your rrd folder and make sure you have your cron setup correctly (bottom of the install guide).

Sincerely,

Joshua Hopper, A+ CE

Network Administrator

420 3^rd Ave NW Hickory NC 28601

Office: 828-449-1839x2160 | Cell: 828-855-7565

From: observium [mailto:observium-bounces@observium.org] On Behalf Of Vmman
Sent: Thursday, December 12, 2013 3:19 PM
To: observium@observium.org
Subject: [Observium] New install no graphs

I'm a beginner, installed observium on Centos 6.5 64bit, I am able to see my device but no graphs.

This is what i'm seeing , any help would greatly be appreciated,

Thanks

Mark

Inline image 1

_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium