You can disable this per device in the web interface; changing the config disables it for all devices (you can then re-enable it per device, too).

Tom

On 21/05/2013 13:01, norbi wrote:

Hi Dario,

still the same :(
but nice hint, i have changed "$config['poller_modules']['q-bridge-mib-fdb']" to "0", that works.

norbert

Am 21.05.2013 12:51, schrieb Dario Calamai:
Hi Norbert,

try to write this lines in your config.php:

$config['poller_modules']['mac-accounting'] = 0;

$config['discovery_modules']['mac-accounting'] = 0;

On Tue, May 21, 2013 at 10:53 AM, norbi <norbi@rocknob.de> wrote:

hi List,

how can i disable the reading of the entire mac-address-table from switches?
problem is, we have about 4000 ports, 129 switches, and snmpbulkwalk needs about 22sec for one run, because the mac-address-table from uplinkports are to big.

norbert
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium

--
dario calamai
http://www.linkedin.com/in/dariocalamai
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium