Aaron,
That's the maximum value for ifSpeed - "normally" one would expect ifHighSpeed to be filled with the correct speed (it's in Mbps instead of bps) - and we should be using that if available. Could you perhaps check with a debug run (or snmpwalk) if that is being returned and we are somehow ignoring it?
Tom
On 16/10/2015 20:51, Aaron Finney wrote:
Just FYI, the 10G ports on a QFX 5100 running latest JunOS are being reported with a speed of 4.29Gbps, which I assume is likely the actual returned value being constrained by a 32-bit container?
Not a critical thing for us to fix - I was actually disabling polling for all of our Juniper vcp stacks in Observium (most of them take > 300s to complete a polling cycle) but noticed this as I was going through them and figured I'd pass it along.
Cheers,
Aaron
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium