show controllers tenGigE 0/0/2/3 phy
Fri Jul 26 10:43:13.640 Summer

SFP EEPROM  port: 3
        Xcvr Type: SFP
        Xcvr Code: SFP-10G-LR
        Encoding: 64B66B
        Bit Rate: 10300 Mbps
        Link Reach 9u fiber (Km): 10000 meter
        Link Reach 9u fiber (100m): 10000 meter
        Vendor Name: CISCO-SUMITOMO  
        Vendor OUI: 00.00.5f
        Vendor Part Number: SPP5200LR-C6     (rev.: B   )
        Laser wavelength: 1310 nm (fraction: 0.00 nm)
        Optional SFP Signal: Tx_Disable, Tx_Fault, LOS
        Vendor Serial Number: SPC1820003Z    
        Date Code (yy/mm/dd): 14/05/12  lot code: 78
        Diagnostic Monitoring: DOM, Int. Cal.,
        Enhanced Options: SW RX LOS Mon., SW TX Fault Mon, SW TX Disable, Alarm/Warning Flags

MSA Data
0x0000: 03 04 07 20 00 00 00 00 : 00 00 00 06 67 00 0a 64
0x0010: 00 00 00 00 43 49 53 43 : 4f 2d 53 55 4d 49 54 4f
0x0020: 4d 4f 20 20 00 00 00 5f : 53 50 50 35 32 30 30 4c
0x0030: 52 2d 43 36 20 20 20 20 : 42 20 20 20 05 1e 00 06
0x0040: 00 1a 00 00 53 50 43 31 : 38 32 30 30 30 33 5a 20
0x0050: 20 20 20 20 31 34 30 35 : 31 32 37 38 68 f0 03 4f
0x0060: 00 00 0b a2 64 ac 18 cb : 55 a5 90 85 ec 03 97 1f
0x0070: 2e b1 97 00 00 00 00 00 : 00 00 00 00 bd 13 55 a4

        Thresholds:                    Alarm High         Warning High          Warning Low            Alarm Low
              Temperature:            +75.000 C             +70.000 C              +0.000 C              -5.000 C
                  Voltage:           3.630 Volt            3.465 Volt            3.135 Volt            2.970 Volt
                     Bias:         90.000 mAmps          84.000 mAmps          24.000 mAmps          20.000 mAmps
           Transmit Power:  2.23870 mW (3.49996 dBm)   1.12200 mW (0.49993 dBm)   0.15140 mW (-8.19874 dBm)   0.06030 mW (-12.19683 dBm)
            Receive Power:  2.23870 mW (3.49996 dBm)   1.12200 mW (0.49993 dBm)   0.03630 mW (-14.40093 dBm)   0.01450 mW (-18.38632 dBm)
        Temperature: 36.688
        Voltage: 3.293 Volt
        Tx Bias: 47.504 mAmps
        Tx Power:  0.44510 mW (-3.51542 dBm)
        Rx Power:  0.10330 mW (-9.85900 dBm)
        Oper. Status/Control:
EEPROM Memory (A2 lower)
0x0100: 4b 00 fb 00 46 00 00 00 : 8d cc 74 04 87 5a 7a 76
0x0110: af c8 27 10 a4 10 2e e0 : 57 73 02 5b 2b d4 05 ea
0x0120: 57 73 00 91 2b d4 01 6b : 00 00 00 00 00 00 00 00
0x0130: 00 00 00 00 00 00 00 00 : 00 00 00 00 00 00 00 00
0x0140: 00 00 00 00 3f 80 00 00 : 00 00 00 00 01 00 00 00
0x0150: 01 00 00 00 01 00 00 00 : 01 00 00 00 00 00 00 3c
0x0160: 24 b0 80 a7 5c c8 11 63 : 04 09 00 00 00 00 00 00
0x0170: 00 00 00 00 00 00 00 00 : 00 00 00 00 00 00 00 01

        CLEI Code: COUIA75CAA
        Part Number: 10-2457-02 (ver.: V02 )
        Temp/Alarm/Power Flags: COM, commercial 0C to 70C
        Minimum Temperature: 0
        Maximum Temperature: 70
        Calibration Constants: LBC Scale, Temperature, Laser bias current, Output power,
        Product Id: SFP-10G-LR          
EEPROM Memory (A2 upper)
0x0180: 43 4f 55 49 41 37 35 43 : 41 41 31 30 2d 32 34 35
0x0190: 37 2d 30 32 56 30 32 20 : 01 00 46 00 00 00 00 b0
0x01a0: 00 00 00 00 00 00 00 00 : 00 00 8c dd 94 00 ac a5
0x01b0: d6 cd 00 00 1e 00 50 3e : 11 70 0f 2d 00 00 aa aa
0x01c0: 53 46 50 2d 31 30 47 2d : 4c 52 20 20 20 20 20 20
0x01d0: 20 20 20 20 32 33 00 00 : 00 00 00 00 00 00 00 2e
0x01e0: 20 26 2b 30 33 36 2b 36 : 00 00 00 00 00 00 00 00
0x01f0: 00 00 00 00 00 6b 00 00 : ff ff ff ff 00 00 00 00

Maybe this is the problem ?