hi, I'm new to Observium, i installed it on Friday. I just added our AKCP temperature sensor and it was detected as an AKCP sensor - sweet. !!!!
however, there eventlog says that the temperature sensors were added, there are no graphs for it.
It's a two sensor device, we only have one connected.
the rrd files created are ospf-statistics.rrd perf-poller.rrd ping.rrd ping_snmp.rrd port-1.rrd sensor-humidity-akcp-0.rrd sensor-humidity-akcp-1.rrd status.rrd uptime.rrd
Where might the missing information be ???? how to get it operational ?
"snmpwalk 10.246.4.42 -v1 -c public 1.3.6.1.4.1.3854.1" works just fine, so the device.
On screen i have ....
Humidity
TCV CR Humidity 2 48.00%
TSV CR Humidity 1 0.00%
Events
364d 13h 12m System Hardware -> AKCP sensorProbe2 v 2.0
364d 13h 12m System sysDescr -> sensorProbe2 v 2.0 SP2406i 280110
364d 13h 12m System sysName -> its test chamber probe
364d 13h 12m System sysObjectID -> .1.3.6.1.4.1.3854.1
364d 13h 15m System Sensor Added: temperature akcp 1 ITS TC Temp 2
364d 13h 15m System Sensor Added: temperature akcp 0 ITS TC Temp 1
364d 13h 15m System Sensor Added: humidity akcp 1 TCV CR Humidity 2
364d 13h 15m System Sensor Added: humidity akcp 0 TSV CR Humidity 1
364d 13h 15m akcp IPv4 added: 10.246.4.42/17
thanks in advance. Peter
********************************************************************** The information contained in this e-mail (including any attachments) is for the exclusive use of the addressee. If you are not the intended recipient please notify the sender immediately and delete this e-mail. It is noted that legal privilege is not waived because you have read this e-mail. **********************************************************************