Hi,

Its ok I managed to figure it out!

I was reading something last nite somewhere about trying to improve the poller times to get it under the 300s, as mines currently polling out at 334s

And I put in my config.php - $config['snmp']['max-rep'] = TRUE;

The minute I removed this, its back to 9s :) 

Thank you anyways 

And I will remember screenshots next time!

Regards

Simon


On 31 Jan 2018, at 15:30, Adam Armstrong <adama@observium.org> wrote:

I'm not sure I believe that it used to take 9 seconds. (this is why you need to provide screenshots to support any information you give)

There's > 5.5 seconds of ports snmp queries, 2.5 seconds of failed ospf queries, and 3.9 seconds of fdb snmp queries in that log alone.  That is ~12 seconds by itself. 

Why is your device now responding more slowly to queries?

adam.

On 2018-01-31 15:17:45, Simon Mousey Smith <simonsmith5521@gmail.com> wrote:

Hi All

Im trying to work out why 1 of our switches has all of a sudden decided to now take 28s to poll, even tho using it for months its only taken 9s?

From the 'tab=perf' of the device, its showing ‘ports’,’fdb-table’,’netstats’,’ospf’ are showng as really high, 9sec each really?

I have restarted the equipment incase it was maybe that, same issue

Ive upgraded to the latest firmware too but still the same issue?

Any other ideas where I can look?

Output of  /opt/observium/poller.php -h 18 -r -dd      https://pastebin.com/Bdpm3abQ

HP Procurve 1810G - 8GE, P2.22

Regards

Simon


_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium