I'm not sure when it was added, but I think it should solve this issue (a better solution would be for vendors to not be so rubbish, but lets not get carried away!)

adam.

So after looking at this more this interface is a back plane connected to an ASA firewall module, and snmp just reports these things improperly :/

What is the best way to ignore this interface for traffic usage alert checks?

Note that because this is a back plane interface there is not way to set a description :/ (because Cisco)

From: observium <observium-bounces@observium.org> on behalf of Tony Marquardt <tomarquardt@kern.org>
Reply-To: Observium Network Observation System <observium@observium.org>
Date: Wednesday, December 30, 2015 at 1:05 PM
To: 'Observium Network Observation System' <observium@observium.org>
Subject: Re: [Observium] TenG port shows up as 1g

This will happen is you have a 1gbps SFP / connection. It will show actual connection speed. Verify at the device you actually have 10gbps connection.

Thank you,

Tony Marquardt

Network Operations Coordinator

Kern County Superintendent of Schools

V: 661-636-4545

E: tomarquardt@kern.org

From: observium [mailto:observium-bounces@observium.org] On Behalf Of Jeffrey d'Ambly
Sent: Wednesday, December 30, 2015 1:03 PM
To: observium@observium.org
Subject: [Observium] TenG port shows up as 1g

I’m using Observium Enterprise and it seems to think this port is 1g (port speed is displayed as 1Gbps) , clicking on the data button shows the following for int speed, and int hight speed. Are these the right values for a 10g port?

fSpeed=>1000000000

ifHighSpeed=>1000