yes, I'm seeing more data than I have, the polling is not working in the cron jobOn Thu, Dec 12, 2013 at 3:58 PM, Josh Hopper <joshhopper@protectplus.com> wrote:
Did you type
cd /opt/observium
sudo chmod 755 rrd
--
Sincerely,
Joshua Hopper, A+ CE
Network Administrator
420 3rd Ave NW Hickory NC 28601
Office: 828-449-1839x2160 | Cell: 828-855-7565
From: observium [mailto:observium-bounces@observium.org] On Behalf Of Vmman
Sent: Thursday, December 12, 2013 5:39 PM
To: Observium Network Observation System
Subject: Re: [Observium] New install no graphs
when I run the command ./poller.php -h all as the install guide shows I get a permission denied.
when I run it like this php poller.php -h all it runs fine.
I think that is why my cron job is not working correctly. Is yours running exactly as install guide show? Thanks
On Thu, Dec 12, 2013 at 3:03 PM, Josh Hopper <joshhopper@protectplus.com> wrote:
Verify cron and your SNMP.conf file.It took a discovery poller and time before mine populated.Vmman <vmman50@gmail.com> wrote:Thank you
I'm monitoring a device that I did not not setup, spoke too soon on the graphs. I think my cron job is not working correctly.
After doing the chmod on the rrd directory I did a polling manually and now I see memory, processor, temp reading but no graphs. So close
Mark
On Thu, Dec 12, 2013 at 2:37 PM, Josh Hopper <joshhopper@protectplus.com> wrote:
Add a sysContact to your switch and add it on the device in observium. Click the gear when drilled down to a device. Just the switch one is required but both helps in rare cases.Also, my pleasure.Vmman <vmman50@gmail.com> wrote:Joshua thank you very much, that seems to have worked.
Sorry to bug you I have another question
I'm monitoring a Cisco switch, how do you get the location correct on the global map?
Mark
On Thu, Dec 12, 2013 at 1:34 PM, Josh Hopper <joshhopper@protectplus.com> wrote:
You have the same issue I just fixed.
Chmod 775 on your rrd folder and make sure you have your cron setup correctly (bottom of the install guide).
--
Sincerely,
Joshua Hopper, A+ CE
Network Administrator
420 3rd Ave NW Hickory NC 28601
Office: 828-449-1839x2160 | Cell: 828-855-7565
From: observium [mailto:observium-bounces@observium.org] On Behalf Of Vmman
Sent: Thursday, December 12, 2013 3:19 PM
To: observium@observium.org
Subject: [Observium] New install no graphs
I'm a beginner, installed observium on Centos 6.5 64bit, I am able to see my device but no graphs.
This is what i'm seeing , any help would greatly be appreciated,
Thanks
Mark
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
