I think i'm running into the original behavior. Graphs looks the same for bps/pps. The port-channel interface has 4 Gig links in it. The physical links and the port channel dont seem to reflect the email usage rates. Anything else I can grab?
Thanks, Chip
Port saturation threshold alarm: cisco.switch.net on GigabitEthernet9/8
Rates:1.6Gbps/5.94Gbps(160/594) >85% of 1Gbps
switch#sh int g9/8
GigabitEthernet9/8 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0021.a082.1bd5 (bia 0021.a082.1bd5)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 3y47w, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 33000 bits/sec, 29 packets/sec
5 minute output rate 10000 bits/sec, 10 packets/sec
473713393 packets input, 43716255496 bytes, 0 no buffer
Received 3 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1489063314 packets output, 161946605971 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
switch#sh run int g9/8
Building configuration...
Current configuration : 345 bytes
!
interface GigabitEthernet9/8
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 21
switchport trunk allowed vlan 21,54,900-999
switchport mode trunk
no ip address
no logging event link-status
no snmp trap link-status
mls qos trust dscp
no cdp enable
channel-group 92 mode on
end
switch#sh int port-channel 92
Port-channel92 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0021.a082.1bd5 (bia 0021.a082.1bd5)
MTU 1500 bytes, BW 4000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
Members in this channel: Gi9/5 Gi9/6 Gi9/7 Gi9/8
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
switch#sh int g9/7
GigabitEthernet9/7 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0021.a082.1bd4 (bia 0021.a082.1bd4)
Description: WiSM WLC W06
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 3y47w, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 43000 bits/sec, 26 packets/sec
5 minute output rate 25000 bits/sec, 14 packets/sec
575824416 packets input, 103856301413 bytes, 0 no buffer
Received 39987948 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1091712210 packets output, 132237718830 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
switch#sh int g9/6
GigabitEthernet9/6 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0021.a082.1bd3 (bia 0021.a082.1bd3)
Description: WiSM WLC W06
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 3y47w, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 35000 bits/sec, 32 packets/sec
5 minute output rate 17000 bits/sec, 17 packets/sec
455573656 packets input, 45036750706 bytes, 0 no buffer
Received 13735 broadcasts (13730 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
4443952461 packets output, 465654922995 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
switch#sh int g9/5
GigabitEthernet9/5 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0021.a082.1bd2 (bia 0021.a082.1bd2)
Description: WiSM WLC W05
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 3y47w, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 30000 bits/sec, 27 packets/sec
5 minute output rate 21000 bits/sec, 26 packets/sec
403436684 packets input, 40480753309 bytes, 0 no buffer
Received 1 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2796049316 packets output, 230244339432 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
switch#
5 minute input rate 152000 bits/sec, 118 packets/sec
5 minute output rate 67000 bits/sec, 63 packets/sec
1968280446 packets input, 240101899166 bytes, 0 no buffer
Received 41602472 broadcasts (13976 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
10094487685 packets output, 1015850895073 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
switch#
On Mon, Jan 20, 2014 at 5:59 PM, Adam Armstrong adama@memetic.org wrote:
On 2014-01-20 16:50, Chip Pleasants wrote:
The graphs look good. The bps/pps graphs mirror each other. I created a Port alert for ifInOctets_perc/ifOutOctets_perc with a 20 min wait for all my cisco devices a couple hours ago.
The delay helps at filtering out spikes and false positives a lot!
I don't think you can change it after alert creation, though. I need to fix that!
adam.
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium