You might want to start by actually using the command I gave you, rather than a rough interpretation of it.
adam.
------ Original Message ------ From: Jacek.Dabrowski@selgros.pl To: observium@observium.org Sent: 2018-04-17 09:06:55 Subject: Re: [Observium] APC ATS - Output/Input voltage
Hi,
I'm not an expert, but here is a mish-mash (from other devices APC-UPS !!!), Adam, you can look at the attachment.
Regards,
Jacek Dąbrowski
From: observium observium-bounces@observium.org On Behalf Of Adam Armstrong Sent: Monday, April 16, 2018 10:34 PM To: Observium observium@observium.org Subject: Re: [Observium] APC ATS - Output/Input voltage
It seems likely that this device is failing to respond to these OIDs using GET, but they worked using WALK (as used during discovery, and I assume OidView).
You should verify you can snmpget these OIDs before going any further.
You can get the exact commandline we use to query them by doing ./poller.php -h <host> -m sensors -d
adam.
------ Original Message ------
From: Jacek.Dabrowski@selgros.pl mailto:Jacek.Dabrowski@selgros.pl
To: observium@observium.org mailto:observium@observium.org
Sent: 2018-04-16 09:46:32
Subject: [Observium] APC ATS - Output/Input voltage
Hello,
I have a problem with Rack-mount Transfer Switches from APC
Observium shows zero voltage but OidView returns the correct values, what is wrong ?
Best regards,
Jacek Dąbrowski
