Try run manually same command and small modifications:
(same)
snmpbulkwalk -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
(with timeout 3 sec)
snmpbulkwalk -t 3 -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
(set minimal repetition)
snmpbulkwalk -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
(no bulk)
snmpwalk -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
(no bulk with timeout 3)
snmpwalk -t 3 -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
you can stop on first responded.
Eduardo Silvestre wrote on 16/09/2018 02:02:
Hello Mike,
I've tried to setup observium with rrdcache but the polling stop working after apply configuration. However, permissions seems to be fine.
Nevertheless, when i've running poller.php -d -h myswitch" and got snmp timeouts but when run same command through command line works fine.
CMD[/usr/bin/snmpbulkwalk -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry]
CMD EXITCODE[1]
CMD RUNTIME[2.0631s]
STDOUT[
]
STDERR[
Timeout: No Response from udp:********:161
]
SNMP STATUS[FALSE]
SNMP ERROR[#1002 - Request timeout]
I've a lot of switch with same IOS and same module but just two of them are with this behavior.
Any idea?
Best Regards,
--
Melhores Cumprimentos | Best Regards,—Eduardo Silvestre
ptisp | wherever internet can take you…helpdesk: +351 249 739 099 | mobile: +351 91 536 46 43
_______________________________________________ observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium