Hi Sam,
It would likely help if you could post a "./poller.php -h yourcisco -m sensors -d" output for analysis.
Tom
On 29/12/2015 00:14, Sam Hernandez-gill wrote:
Going back through some old mailing lists, didn’t see a reply to this one: http://postman.memetic.org/pipermail/observium/2015-April/010117.html
I have the same issue here on Cisco 6880-X’s. Sh Env shows no problem with Fan Tray 1 50V Power Supply status, but observium alerts on the snmp status of the C6880-X Fan Tray 1 – Fan Tray 1 50V Power Supply.
From any C6880-X itself:
fan-tray 1:
fan-tray 1 type: C6880-X-FAN
fan-tray 1 mode: Mode1
fan-tray 1 fan-fail: OK
fan-tray 1 50V Power Supply: OK
fan-tray 1 firmware version: 7
I believe this is OID http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=T...
Object
cevSensorFanTrayStatus
OID
1.3.6.1.4.1.9.12.3.1.8.37
Currently with a status alert checker observium will generate an alert for this. So how can I help determine if the switch is really saying the Fan Tray power status Is bad via snmp or if it’s just a problem in how observium is interpreting the response?
Thanks,
This message (including any attachments) contains confidential information intended for a specific individual and purpose, and is protected by law. If you are not the intended recipient of this e-mail (even if the e-mail address above is yours), (i) you may not use, copy or retransmit it, (ii) please delete this message and (iii) please notify the sender immediately. Any disclosure, copying, or distribution of this message or the taking of any action based on it, is strictly prohibited.
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
