Hi
Sorry, but I mistakenly replied to Adams email just to him.
The problem solved it self after som troubleshooting and reboot of switch 2 in the stack. Now I can see all the info I missed before.
Thanks for responding though.
Regards
Daniel
From: "Mike Stupalov" <mike@observium.org>
To: "observium" <observium@observium.org>, "observium" <observium@observium.org>
Cc: "Daniel Johansson" <daz@voodoo-people.com>
Sent: Thursday, February 6, 2020 1:18:25 PM
Subject: Re: [Observium] Cisco 9300-24p in stack with 3 units not showing all info for stack member 2
Hi Daniel,
please make discovery debug:
./discovery.php
-d -h <device>
And better than, full snmp dump from
this (main stack) device:
snmpwalk -v2c -c <community>
--hexOutputLength=0 -ObentxU <hostname> .1 > myagent.snmpwalk
snmpwalk
-v2c -c <community> --hexOutputLength=0 -ObentxU
<hostname> .1.3.6.1.4.1 >> myagent.snmpwalk
Daniel Johansson via
observium wrote on 06.02.2020 12:17:
Hi
After
setting up a new stack with 3 units of C9300-24p we only see the full
inventory for switch 1 and switch 3 not switch 2.
That means I
can't see the fans or temp sensors for switch 2.
Is this an
observium parsing issue or an snmp issue in the switches?
I attach a full picture of the inventory
page.
i also have a full snmpwalk dump from the switch if you
need to have a look at it. Will send it outside of the list if needed.
_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium