Hi Adam,

My bad, I have missed one step during the set-up. I can see the UNIX-client in my remote serer. However, I have another question/problem: 

I added the snmp client to my snmp remote and it is fine. Then I set-up observium in the client and I try to pull the data from itself (Basically the same device is polled from a remote server and from itself) I can add the device (on the local observium) but I cannot pool any data (see screenshot). Below you can find the config for snmpd

Immagine incorporata 1

#  AGENT BEHAVIOUR

#

#  Listen for connections from the local system only

#agentAddress  udp:127.0.0.1:161

#  Listen for connections on all interfaces (both IPv4 *and* IPv6)

agentAddress udp:161,udp6:[::1]:161

#  ACCESS CONTROL
#

                                                 #  system + hrSystem groups only
view   systemonly  included   .1.3.6.1.2.1.1
view   systemonly  included   .1.3.6.1.2.1.25.1

                                                 #  Full access from the local host
rocommunity public  localhost
                                                 #  Default access to basic system info
#rocommunity public  default    -V systemonly
                                                 #  rocommunity6 is for IPv6
#rocommunity6 public  default   -V systemonly

                                                 #  Full access from an example network
                                                 #     Adjust this network address to match your local
                                                 #     settings, change the community string,
                                                 #     and check the 'agentAddress' setting above
rocommunity secret  87.81.223.210

                                                 #  Full read-only access for SNMPv3
rouser   authOnlyUser

Thakls!


On 15 Nov 2015 18:14, "Adam Armstrong" <adama@memetic.org> wrote:
Hi Frederico, 

You install the agent in the same way, it's not difficult!

What exactly isn't working?

adam.

On 15/11/2015 16:16:26, Federico Olivieri <lvrfrc87@gmail.com> wrote:

Hi All

I have a server that is running Observium with Unix Agent and everything is ok. Recently I installed a second remote server and is a SNMP client on my observium. Because this server is running Power DNS I would enable the UNIX-AGENT om this client and see the graphs for pdns on my Observium. 

Can anyone assist me on this?

Thank You very much

Federico 
_______________________________________________ observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium

_______________________________________________
observium mailing list
observium@observium.org
http://postman.memetic.org/cgi-bin/mailman/listinfo/observium