Hi,

Running an SRX4200 cluster (Junos 15.1X49-D110), I’m not able to see the FANs’ status / spinning speed :

root@fw01-par01> show chassis fan

node0:

--------------------------------------------------------------------------

Item Status RPM Measurement

FPC 0 Tray 0 Fan 0 OK 8181 Spinning at normal speed

FPC 0 Tray 0 Fan 1 OK 9000 Spinning at normal speed

FPC 0 Tray 1 Fan 0 OK 8083 Spinning at normal speed

FPC 0 Tray 1 Fan 1 OK 8940 Spinning at normal speed

FPC 0 Tray 2 Fan 0 OK 7941 Spinning at normal speed

FPC 0 Tray 2 Fan 1 OK 9183 Spinning at normal speed

FPC 0 Tray 3 Fan 0 OK 8132 Spinning at normal speed

FPC 0 Tray 3 Fan 1 OK 8940 Spinning at normal speed

root@fw01-par01> show chassis environment

node0:

--------------------------------------------------------------------------

Class Item Status Measurement

Power FPC 0 Power Supply 0 OK

FPC 0 Power Supply 1 OK

Temp System Temp1 - Front OK 29 degrees C / 84 degrees F

System Temp2 - Back OK 39 degrees C / 102 degrees F

CPU0 Temp OK 70 degrees C / 158 degrees F

CPU1 Temp OK 61 degrees C / 141 degrees F

Fans FPC 0 Fan Tray 0 OK Spinning at normal speed

FPC 0 Fan Tray 1 OK Spinning at normal speed

FPC 0 Fan Tray 2 OK Spinning at normal speed

FPC 0 Fan Tray 3 OK Spinning at normal speed

Attached are sensors and status pollers run in debug, no mention at all of the required OIDs. According to Juniper documentation :

Is this something missing on Observium side ?

Thank you.