Deleting the device without removing the rrds, and adding it back did the trick nicely.
Thanks again Tom,
R. Prihoda T. 512-306-9898 x107 www.dynaConnections.com
On Jan 17, 2014, at 3:59 PM, Tom Laermans tom.laermans@powersource.cx wrote:
Aha!
Well, if you turn off the services part and poller, the alerts are probably not purged from the database. And as the services poller no longer runs, it'll never fix itself...
Best to truncate the services table in the database to get rid of this then.
Tom
On 17/01/2014 22:30, ryan wrote: Tom,
I saw that and turned it off in config, yet the problem still persisted. That is why I was confused as to why the alerts weren't going away.
Thanks again,
R. Prihoda
On Fri, 2014-01-17 at 21:51 +0100, Tom Laermans wrote: Hi,
Please do not use service checks in Observium, as the documentation notes.
Thanks, Tom
On 17/01/2014 18:44, ryan wrote:
Hello all,
I have attached an image of the alerts in question, the names and locations have been removed. It only happens on these two servers out of 20+ different servers. What causes this behavior ? I cannot seem to find any differences between servers. I am using the community edition on centos 6.5 , if that helps at all.
Thanks,
R. Prihoda
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium