Hello,

In the menu Ports -> Pseudowires -> All types i can only find the pseudowires that start on a cisco machine.

Nu juniper are in that list (there are a few as destination node).

Do I have to configure something to show the Juniper routing instances?

Regards,

Met vriendelijke groet,

Peter Derissen Eurofiber Nederland

Network Engineer Safariweg 25-31

+31 (0)6 11587110 3605 MA Maarssen

Volg ons op Twitter | Linkedin | Youtube

******** IMPORTANT NOTICE ********
This e-mail (including any attachments) may contain information that is confidential or otherwise protected from disclosure and it is intended only for the addressees. If you are not the intended recipient, please note that any copying, distribution or other use of information contained in this e-mail (and its attachments) is not allowed. If you have received this e-mail in error, kindly notify us immediately by telephone or e-mail and delete the message (including any attachments) from your system.

Please note that e-mail messages may contain computer viruses or other defects, may not be accurately replicated on other systems, or may be subject of unauthorized interception or other interference without the knowledge of sender or recipient. Eurofiber only sends and receives e-mails on the basis that Eurofiber is not responsible for any such computer viruses, corruption or other interference or any consequences thereof.
Eurofiber Nederland B.V. is registered in the Chamber of Commerce of Amsterdam with number 34134377, VAT number NL 8088.51.524 B01.