Hi Tom....
Thanx for this. I had a look at the code you mention above. I'll have a go at updating it with the ctrlOutlet tree.
However, I noticed that it already has code for the ctrl3ChIEC tree, and the snmpwalk output I attached earlier shows that my PDU supports this and reports power stats. However, none of these are monitored/graphed for my PDU in Observium....
I'm guessing these are power stats for the PDU as a whole (not for individual outlets).
Should these stats be showing up in my Observium setup as graphs etc?
Thanx in advance.
Chris.
On 6 January 2015 at 17:08, Tom Laermans tom.laermans@powersource.cx wrote:
Hi Chris,
Apparently I coded a whole bunch of possible sensor types for the Geist PDUs back in the day (everything I could get my hands on) but the ctrlOutlet tree was not one of them.
You can find the code includes/discovery/sensors/geist-mib-v3.inc.php if you want to give it a go, if not, sponsored development is always an option :-)
Tom
On 01/06/2015 03:48 PM, cwbshaw . wrote:
Hi....
Thanx for that. I had wondered the same myself, but I have done the following which reads in the Geist mib:
snmpwalk -v2c -c public -m GEIST-MIB-V3 -M +/opt/observium/mibs/geist s202-r1c1pdu-1 enterprises.21239.2
....and it worked. I have attached the output.....
Is there a log or some debug output in observium I could use to get more information?
Thanx in advance.
Chris.
On 6 January 2015 at 13:22, Tom Laermans tom.laermans@powersource.cx wrote:
Hi Chris,
We have full support for the Geist V3 and V4 MIBs. Possibly your device uses a different MIBs?
Tom
On 01/06/2015 02:12 PM, cwbshaw . wrote:
Hi....
I have been using Observium for a while now and really like it....
Recently I added a Geist smart PDU to monitor it.....it does seem to recognise it, but all it seems to monitor is various network stats. I had been hoping it might automatically begin monitoring voltage, current, watts etc. for both the PDU as a whole and even if possible its individual outlets.
It does recognise it as a Geist PDU and the inventory for the unit does correctly show it as having 24 controlled power outlets. However, there is no 'Health' tab and it doesn't seem to graph or monitor any of the electrical stats for the PDU or its outlets.
I was just wondering if maybe I have done something wrong, or it it that currently the Geist PDU is not fully supported and that monitoring a Geist PDU this way is a work in progress?
If it is still a work in progress, I'd be willing to have a go at getting (or helping to get) Observium to support monitoring the PDU fully, but I'm a bit lost as to where to begin. I know a reasonable amount about PHP and SNMP, but am no expert.
Thanx in advance for any help.
Chris Bradshaw.
observium mailing listobservium@observium.orghttp://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing listobservium@observium.orghttp://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium