It seems this device is /also/ not returning correct data for these ports. You won't get very far with 32bit counters on a TE port :)

Check what it's reporting via SNMP. It's likely not really anything to do with us.

adam.

Sent from Mailbird

On 09/07/2015 14:21:04, Johnston, Tom <tom.johnston@edinaschools.org> wrote:

2960X switches and newer styles of switches have dual speed SFP slots. On my 2960X I have switched from 1GIG SFP to a 10GIG SFP.

This changes the ports from GigabitEthernet to TenGigabitEthernet.

In the switch config now the GigabitEthernet ports are gone (they get removed from running config) and now TenGigabit Ports are present and in use.


Observium still shows both types of interfaces present, and there is none to delete under ports. It also doesn’t show that the TenGig port is up even though it is up. Whats the best way to handle this? Delete/re-add switch?

Te1/0/1                      connected    trunk        full    10G SFP-10GBase-LRM (was the gigabit 1/0/49)
Te1/0/2                      notconnect   1            full    10G Not Present (was the gigabit 1/0/50)
Po2       VV-6504            notconnect   1            auto   auto
Fa0                          disabled     routed       auto   auto 10/100BaseTX
VV-IDF3-2960X01#

10149 GigabitEthernet1/0/49
VV-6504 G4/8		 Ethernet
enabled / down
NoYes
NoYes
 64bit
10150 GigabitEthernet1/0/50
VV-6504 G4/9		 Ethernet
enabled / down
NoYes
NoYes
 64bit
10201 TenGigabitEthernet1/0/1
 Ethernet
enabled / down
NoYes
NoYes
 32bit
10202 TenGigabitEthernet1/0/2
 Ethernet
enabled / down
NoYes
NoYes
 32bit
Thanks in advance




Thanks in advance