This is
probably because you're polling through a firewall which has session or
other rate limits.
Adam.
Hello Mike,
I've tried to setup observium with rrdcache but the polling stop
working after apply configuration. However, permissions seems to be
fine.
Nevertheless, when i've running poller.php -d -h myswitch" and got snmp
timeouts
but when run same command through command line works fine.
CMD[/usr/bin/snmpbulkwalk -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M
/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp
'udp':'********':'161' ifXEntry]
CMD EXITCODE[1]
CMD RUNTIME[2.0631s]
STDOUT[
]
STDERR[
Timeout: No Response from
udp:********:161
]
SNMP STATUS[FALSE]
SNMP ERROR[#1002 - Request timeout]
I've a lot of switch with same IOS and same module but just two of them
are with this behavior.
Any idea?
Best Regards,
Hi Wilbert
I have a
4 Core with HT Xeon E3 1270 CPU @ 3.5Ghz
32GB Ram
Then 3 Raid
1 Arrays on Fast SSD Drives
1 for System, 1 for MySQL and 1 for RRD
The
RRD one has to be on a Enterprise SSD which can handle big amounts of
writes (several 10GB/5min)
else it will get broken very fast. To
reduce writes on the SSD I also recommend using rrdcached.
Regards
Matthias
What would be your recommendation the cpu, memory, hard disk
since it is estimated to have up to 1500 devices?
Wilbert.