Try this:
$config['bad_if_regexp'][] = '/^.pppoe-/'; $config['bad_if_regexp'][] = '/^.pptp-/';
2015-12-24 11:33 GMT-02:00 Alasdair MacLeod Alasdair@jhcs.com:
Observium also detects all the PPPoE connections as interfaces (not ports).
Is it possible to tell observium to ignore all Ports / Interfaces excluding those I stipulate?
At the moment, on this router im testing with, it has picked up over 800 additional interfaces which I don’t care about. Im concerned that this will be causing it to do way more work than necessary. If I then add in another 60 odd routers and it does the same to them all, it may cause the workload to be too great.
Thanks.
Al
*From:* observium [mailto:observium-bounces@observium.org] *On Behalf Of *Eduardo Schoedler *Sent:* 24 December 2015 13:27
*To:* Observium Network Observation System observium@observium.org *Subject:* Re: [Observium] MikroTik CCR interface graphs show lower throughput
This is a long time bug in Mikrotik, software-devices are 32-bit only.
--
Eduardo Schoedler
2015-12-24 11:11 GMT-02:00 Alasdair MacLeod Alasdair@jhcs.com:
No, they are being detected as 32bit. How can I fix that?
Thanks.
Regards
*Alasdair MacLeod *Senior Technician
Newark Wireless JHCS Ltd 27-29 Kirkgate Newark, Nottinghamshire, NG24 1AD
www.jhcs.com|Alasdair@jhcs.com <Alasdair@jhcs.com?subject=email%20sent%20by%20reply%20from%20email%20signature>
Tel | +44 (0) 1636 682 244 Fax | +44 (0) 1636 704 571
*From:* observium [mailto:observium-bounces@observium.org] *On Behalf Of *Tom Laermans *Sent:* 24 December 2015 12:55 *To:* Observium Network Observation System observium@observium.org *Subject:* Re: [Observium] MikroTik CCR interface graphs show lower throughput
Hi,
115Mbit is the limit for 32bit counters, are the ports being detected as 64bit?
(See device > properties > ports)
Tom
On Dec 24, 2015 1:39 PM, Alasdair MacLeod Alasdair@jhcs.com wrote:
Hi Guys,
I just started using Observium. Everything looks great except our CCRs are showing much lower throughput on the interfaces than they are actually passing. One interface is passing a fairly consistent 300-400Mbps but Observium graphs it as 100-130Mbps.
Cacti graphs the same interface on the same device correctly so I don’t think it’s the router, I think I must have set something up incorrectly within Observium.
Any pointers on this would be great.
Thanks.
Regards
*Alasdair MacLeod *Senior Technician
Newark Wireless JHCS Ltd 27-29 Kirkgate Newark, Nottinghamshire, NG24 1AD
www.jhcs.com|Alasdair@jhcs.com <Alasdair@jhcs.com?subject=email%20sent%20by%20reply%20from%20email%20signature>
Tel | +44 (0) 1636 682 244 Fax | +44 (0) 1636 704 571
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium