I like order, as something is supported cool to make all sensors work, especially when it comes to critical infrastructure.

Pozdrawiam

Jacek Dąbrowski

From: observium <observium-bounces@observium.org> On Behalf Of Tom Laermans
Sent: Wednesday, April 18, 2018 9:12 AM
To: observium@observium.org
Subject: Re: [Observium] APC ATS - Output/Input voltage

I'm now totally confused about what you're trying to achieve... and I'm fairly sure Adam will have the same issue.

You're being asked to run snmpget/walk commands like the poller, but start adding definitions to a file... which definitely don't belong in there currently as all PowerNet-MIB is discovered through code... then claim it doesn't work. :O

On 4/18/2018 8:00 AM, Jacek.Dabrowski@selgros.pl wrote:

Hi Adam,

I added test entries in apc.inc

$config['mibs'][$mib]['sensor']['atsOutputVoltage']['tables'][] = array(

  'table'   => 'atsOutputPhaseTable',

  'class'   => 'voltage',

  'descr'   => 'Output-test',

  'oid'     => 'atsOutputVoltage',

  'oid_num' => '.1.3.6.1.4.1.318.1.1.8.5.4.3.1.3,',

  'min'     => 210,

  'scale'   => 1, // in V

Debug show correct voltage in discovery.php, the voltage is shown in the observium, after finishing the pooler, the value disappears, why ???, for me debug poller does not bring anything, maybe I cannot interpret it