I would like to add 4.x releases doesn't expose lot of sensors, they did improve that in 5.2 IOS-XR iirc
On 20/01/16 13:59, Frederic Gargula wrote:
Hi Robert,
We figured out that, in order to see the fans and power, we needed to force a manual discovery of our ASR9K from the command-line. I hope this helps.
Best regards,
Frederic Gargula IP-Max SA
On 20 Jan 2016, at 11:43, Robert Williams Robert@CustodianDC.com wrote:
Hi,
I’ve just noticed that fan failures on the ASR 9k are not detected by Observium. In fact, it seems have nothing at all under the ‘status’ tab?
The 6500s have over 20 entries in there for “Fan - Fail” or “PSU - Fail” or “I’m not facing magnetic north - Fail” etc. but the ASR9000 have no status tab whatsoever.
Reason for noticing this; is that we have a chassis which currently has a ‘Major-Alarm’ failure indicator LED on the RSP, due to a failed fan tray. Observium shows the device has being ‘OK’ and is not seeing either the Major alarm or the fan tray failure:
canb-server[151]: %PLATFORM-CANB_SERVER-3-ALARM_INDICATION : Raise alarm from CBC in slot 0/FT0/SP, alarm code CBC_ALRM_FT_LED_RED_FAILED
LED Information
R/S/I Modules LED Status 0/RSP0/* host Critical-Alarm Off host Major-Alarm On host Minor-Alarm Off host ACO Off host Fail Off
FAN0 FAN1 FAN2 FAN3 FAN4 FAN5 FAN6 FAN7 FAN8 FAN9 FAN10 FAN11 FAN12 FAN130/FT0/* (Speed) 9900 9900 9870 9780 9870 9780 9780 10080 10080 9870 9990 9900 9810 9990 (fans are now OK again)
Is this a case of Cisco not exporting any of this useful (and rather critical) information properly? Would be good to graph fan speeds if they are exported. Or are other people getting these OK and it’s just us with the issue?
Cheers!
Robert Williams Custodian Data Centre Email: Robert@CustodianDC.com http://www.CustodianDC.com
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium