How to get revised SNMP settings from existing devices
I’ve been updating parameters in some Cisco switches such as snmp-server location and snmp-server contact. But I don’t see these changes reflected in existing devices. Is there anything else I should do?
Make sure you have not chosen to override these settings in the Observium device settings. Other than that I see the changes typically reflect in the UI within about 5 mins.
Good luck! Alex Chard
-----Original Message----- From: observium [mailto:observium-bounces@observium.org] On Behalf Of Mike Driscoll Sent: Thursday, 14 May 2015 10:36 AM To: observium@observium.org Subject: [Observium] How to get revised SNMP settings from existing devices
I’ve been updating parameters in some Cisco switches such as snmp-server location and snmp-server contact. But I don’t see these changes reflected in existing devices. Is there anything else I should do?
_______________________________________________ observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium This e-mail is for the use of the intended recipient(s) only. If you have received this e-mail in error, please notify the sender immediately and then delete it. If you are not the intended recipient, you must not use, disclose or distribute this e-mail without the author's permission. We have taken precautions to minimise the risk of transmitting software viruses, but we advise you to carry out your own virus checks on any attachment to this e-mail. We cannot accept liability for any loss or damage caused by software viruses.
I use the community version and it updates automatically.
specifically the location however, on some devices, i have "overridden" it in the gui. guess you check that, that hasn't been done.
thanks
Peter Hine Senior Technical Support Engineer (Servers) FCoA ITS peter.hine@familycourt.gov.au
PH : +61 2 6243 8668 FAX : +61 2 6243 5611
From: Mike Driscoll mike.driscoll@oracle.com To: observium@observium.org, Date: 14/05/2015 10:36 AM Subject: [Observium] How to get revised SNMP settings from existing devices Sent by: "observium" observium-bounces@observium.org
I’ve been updating parameters in some Cisco switches such as snmp-server location and snmp-server contact. But I don’t see these changes reflected in existing devices. Is there anything else I should do?
_______________________________________________ observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
********************************************************************** The information contained in this e-mail (including any attachments) is for the exclusive use of the addressee. If you are not the intended recipient please notify the sender immediately and delete this e-mail. It is noted that legal privilege is not waived because you have read this e-mail. **********************************************************************
participants (3)
-
Chard, Alex (RET-SYD) -
Mike Driscoll -
Peter.Hine＠familycourt.gov.au