Just to advice i am seeing a difference between "./discovery.php -h xxxx" and "./discovery.php -h xxxx -d".

I had a PDU which was a bit broken. It's other three PDU mates were corrrectly discovered as apc. The broken one came back as "generic".

after restarting the management interface (on PDU), i ran discovery manually (i didn't want to wait 5 hours for the next scheduled discovery). This didn't change the device.

In looking to see if there was a "force" option, i found the debug option instead. When i ran the discovery with debug, the device changed from generic to apc and it discovered all the other bits to do with a PDU. NOTE !!!!!!!!! - this IS on ubuntu 13.04

So for stamps, i did the same on the openSUSE machine i reported earlier with missing temperature graphs, and sure enough - the temperature sensors were found and added.

So is "debug" an alias for "force" or there something else going on ?

Anyway. Not looking for a fix, just an info about this behaviour.

thanks

Peter Hine Senior Technical Support Engineer (Servers) FCoA ITS peter.hine@familycourt.gov.au

PH : +61 2 6243 8668 FAX : +61 2 6243 5611

********************************************************************** The information contained in this e-mail (including any attachments) is for the exclusive use of the addressee. If you are not the intended recipient please notify the sender immediately and delete this e-mail. It is noted that legal privilege is not waived because you have read this e-mail. **********************************************************************