Thanks for the suggestion Sean,

Unfortunately I couldn’t get your method to work because the 6500 has a load of sensors in the table such as ‘power supply 1 fan’ so using sensor_descr match *power supply* would pull these too and they would fail the check that I have in place.

I have managed to use my original Metric, Condition, Value and Associations by selecting the Entity Type as ’Sensor’ rather than ‘Voltage’. I can live with that :)

Thanks again

Jake Turner

On 2 Sep 2014, at 17:26, Pedersen, Sean <spedersen@io.commailto:spedersen@io.com> wrote:

I just went through this exact exercise last week. A different method was recommended in IRC, and I built the following checker to suit:

Conditions:

sensor_event ne up sensor­_event ne ignore

Devices:

*

Entities:

sensor_class eq state sensor_descr match *power supply*

This uses the built-in state logic to see if the power supply is alive or not. At the moment, I know that Brocade power supplies will go into ‘alert’ state if they are missing or down. I’m assuming the same for Cisco, and that they’d also alert if there were max/min power violations as well. It might not be exact – as in “power supply undervolt!” – but I figure if a PSU is anything but “up” then it deserves to be looked at.

From: observium [mailto:observium-bounces@observium.org] On Behalf Of Jake Turner Sent: Tuesday, September 02, 2014 4:43 AM To: Observium Network Observation System Subject: Re: [Observium] 6500 PSU Voltage Check

Hi,

After looking through the database it seems to make more sense. I've reconfigured it as:

Metric Condition Value sensor_value lt 220

In Associations I have * sensor_class equals voltage.

This still isn't working though.

Jake ________________________________ From: observium [observium-bounces@observium.orgmailto:observium-bounces@observium.org] on behalf of Jake Turner [Jake.Turner@turnerhouse.org.ukmailto:Jake.Turner@turnerhouse.org.uk] Sent: 02 September 2014 12:06 To: observium@observium.orgmailto:observium@observium.org Subject: [Observium] 6500 PSU Voltage Check Hi All,

I was wondering if I could configure alerts for the voltage on a couple of 6500 power supplies (to try and alert on power failures).

I've used the Entity Type of Voltage and this picks up the Enitity's from the 6500 (110/220v AC power supply, 2500 watt 2 - Power Supply 2 power-input) however I'm unsure on how to configure the 'Check Conditions' and 'Associations'. The below is a guess for the check conditions:

Metric Condition Value sensor_voltage lt 220

In Associations I have simply put * * which I suspect is incorrect.

Has anybody else tried setting up checks on voltage?

Thanks

Jake

Founded in 2007, IO is a worldwide leader in software defined data center technology, services and solutions that enable businesses and governments to intelligently control their information.

The communication contained in this e-mail is confidential and is intended only for the named recipient(s) and may contain information that is privileged, proprietary, attorney work product or exempt from disclosure under applicable law. If you have received this message in error, or are not the named recipient(s), please note that any form of distribution, copying or use of this communication or the information in it is strictly prohibited and may be unlawful. Please immediately notify the sender of the error, and delete this communication including any attached files from your system. Thank you for your cooperation.