On 25.05.2013 22:34, Simon Mott wrote:

Hi all

im pretty new to observium but i am loving how easy it is to use so far!

I have a couple of minor issues though

1. i have added two servers that are configured almost identically and

observium has only picked up the lm-sensors info for one of them - is there a way i can force it to get this info from the second server?

lm-sensors extend snmpd so, look into that closer. if snmpd doesn't return these values obs don't show them. Make sure you have actually configured lm-sensors, and sensors command give output.

2. On the note of lm-sensors - Observium is parsing the output of

lm-sensors and treating the threshold values as actual sensors - can i make it just outright not graph these whilst keeping the actual sensor data?

3. I have a windows server added to observium and i am getting a load of

ports that i dont care about - same question as above - can i make observium ignore these ports and not even list them/try to graph them?

Settings-ignore

4. i have unix agent installed on a server exposing hddtemp data but

sometimes when observium polls it doesnt detect all hard disks or sometimes none at all (whilst at the same time i confirm hddtemp is working as expected and showing all disks) Any ideas whats causing this?

Thanks

---

observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium