This is only device/network trouble. (Not configurations/observium/etc)
Try run manually same command and small modifications:
(same) snmpbulkwalk -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry (with timeout 3 sec) snmpbulkwalk -t 3 -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry (set minimal repetition) snmpbulkwalk -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry (no bulk) snmpwalk -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry (no bulk with timeout 3) snmpwalk -t 3 -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry
you can stop on first responded.
Eduardo Silvestre wrote on 16/09/2018 02:02:
Hello Mike,
I've tried to setup observium with rrdcache but the polling stop working after apply configuration. However, permissions seems to be fine.
Nevertheless, when i've running poller.php -d -h myswitch" and got snmp timeouts but when run same command through command line works fine.
CMD[/usr/bin/snmpbulkwalk -Cr'100' -v2c -c *** -Pu -OQUs -m IF-MIB -M /opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp 'udp':'********':'161' ifXEntry]
CMD EXITCODE[1] CMD RUNTIME[2.0631s] STDOUT[
] STDERR[ Timeout: No Response from udp:********:161 ] SNMP STATUS[FALSE] SNMP ERROR[#1002 - Request timeout]
I've a lot of switch with same IOS and same module but just two of them are with this behavior.
Any idea?
Best Regards,
--
*Melhores Cumprimentos | Best Regards,* *—* Eduardo Silvestre ptisp | wherever internet can take you…
eduardo@ptisp.pt mailto:eduardo@ptisp.pt helpdesk: +351 249 739 099 | mobile: +351 91 536 46 43 www.ptisp.pt http://www.ptisp.pt
observium mailing list observium@observium.org http://postman.memetic.org/cgi-bin/mailman/listinfo/observium
