2960X switches and newer styles of switches have dual speed SFP slots. On my 2960X I have switched from 1GIG SFP to a 10GIG SFP.
This changes the ports from GigabitEthernet to TenGigabitEthernet.
In the switch config now the GigabitEthernet ports are gone (they get removed from running config) and now TenGigabit Ports are present and in use.
Observium still shows both types of interfaces present, and there is none to delete under ports. It also doesn’t show that the TenGig port is up even though it is up. Whats the best way to handle this? Delete/re-add switch?
Te1/0/1 connected trunk full 10G SFP-10GBase-LRM (was the gigabit 1/0/49) Te1/0/2 notconnect 1 full 10G Not Present (was the gigabit 1/0/50) Po2 VV-6504 notconnect 1 auto auto Fa0 disabled routed auto auto 10/100BaseTX VV-IDF3-2960X01#
10149 GigabitEthernet1/0/49 VV-6504 G4/8 Ethernet enabled / down No Yes
No Yes 64bit 10150 GigabitEthernet1/0/50 VV-6504 G4/9 Ethernet enabled / down No Yes
No Yes 64bit 10201 TenGigabitEthernet1/0/1 Ethernet enabled / down No Yes
No Yes 32bit 10202 TenGigabitEthernet1/0/2 Ethernet enabled / down No Yes
No Yes 32bit Thanks in advance
Thanks in advance